Roof Trusses

Size Of A Room In An Attic Truss

Question: 

Does SBCA have any guidelines regarding the size of a room in an attic truss? I have used a formula, length of room in inches divided by the depth of the bottom chord equaling less than 22. I was curious if any extensive studies or published articles giving more exact guidelines are available.

Ga Rc 2601

Question: 

In RC 2601, is RC-1 Channel used?

Gable End Bracing

Question: 

Manufactured gable ends are actually frames even though they are often referred to as trusses. The webs are “studs” oriented vertically and usually spaced at 12, 16 or 24 in. O.C. The gable end frame is designed to transfer vertical loads from the roof to the continuous bearing wall below. Another way gable end frames are different from trusses placed in the interior of the structure is that frames experience perpendicular wind loads. The sheathed frame transfers the wind loads to the roof and ceiling diaphragms and vice versa.

Truss Design

Question: 

Recently, I was invited to view a newly-constructed 60 ft. by 36 ft. barn, with homemade big timber trusses as follows: 36 ft. span, 12/9 pitch, construction was 26 ft. 2x12 rafters, bracing 2x6, ceiling joists were 36 ft. boxed, 6x12 out of overlapping (6 ft.), 2x12 glued and nailed center, 16 feet of joist doubled as an 8 ft. high loft, floor trusses were on 12 ft. centers atop posts deeply anchored with good footings, roof and wall cross ties were 2x6 on edge every 24 in., floor cross ties in the loft were 2x8 on edge every 16 in., 4 ft. snow load.

Bracing Schematics

Question: 

Are there any schematics available on how to horizontally brace a 7/12 pitch roof?

Lumber Grades In Truss Design

Question: 

In truss manufacturing, can hemlock, fir and spruce be used instead of Douglas Fir/Larch? What grades can be used: Structural Light Framing (Select Structural through #3) only, or Light Framing (Construction through Utility) as well?

Attachment Of Scissors Trusses

Question: 

What is the correct method of attaching scissors trusses to the top plate? I read recently in a trade magazine that this type of truss should be toe-nailed on one end and attached with slotted clips on the other end. According to the article, this is to allow for movement of the truss. We require PE stamped spec sheets from the truss manufacturer to verify trusses meet wind and snow loads. These sheets give bracing requirements but never give recommended attachment requirements.

Transforming Attic Into Living Space

Question: 

We are looking into developing the attic space above our garage into a media room. The garage is attached to the home and we would enter this area from the living room. We recently read if you have a truss system that in order to develop the attic, one would have to replace the entire roof with conventional construction. My question is: can we safely develop this trussed area above our garage?

One Hour Roof Ceiling Assembly

Question: 

I am looking for a 1-hour roof/ceiling assembly for wood truss construction. I would like to apply the drywall directly to the bottom of the truss and also have insulation for sound control. Is this possible without using channels and what UL number would I use?

Adequate Trusses

Question: 

Where can I find specs for what would be adequate trusses? I have a room with a 24 ft. span and my contractor is using trusses where the bottom plate is composed of 2x4s butted together and fastened with a metal plate. Is this ok?