Moisture Control

Resources Available for Dealing With Mold

September 25, 2018

Framers, home builders, and homeowners looking for best practices to ensure they have the most current mold facts as well as mold mitigation and remediation information can now look to two new research reports created by the Structural Building Component Association (SBCA).

Checklists for Mitigating and Remediating Mold on Wood Structural Building Components

The following checklists are to be used as a practical guide in conjunction with the information on mold provided in SBCA Research Report 1807-01: “Mold on Structural Building Components.”

Mold on Wood Structural Building Components

This research report seeks to provides fact-based information about causes, effects, and mitigation of mold growth on lumber and wood structural building components. 

Continuous Insulation Solves Energy Code Math Problem

April 23, 2018

Continuous insulation (ci) and cavity insulation products are both sold with R-value ratings, but the way these two products are used in wall construction means they do not have the same effectiveness.

Partition Separation Lag Bolting

Question: 

Is lag bolting the bottom chord of a truss to the top plate of a wall a proper fix to correct truss arching, assuming the attic is properly vented?

Floor Trusses With Masonry Bearing Walls

Question: 

We would like to know if there is a problem with using wood floor trusses with masonry bearing walls without a ledger. Our local supplier has told me that encasing the wood truss in the masonry wall could be detrimental to the truss due to moisture. What, if any, suggestions do you have for this condition? If a bottom chord bearing is used, do the trusses need fire cuts? The two-story building contains masonry bearing walls with wood trusses on the second floor and wood trusses at the roof.

Attic Ventilation

Question: 

I need to put a new roof on my single-family dwelling. The house originally had gable and soffit/eave vents. The roofing contractor suggested that we install a ridge vent when new roof is installed. Should the existing gable vents be blocked off or does it not matter? I have read some debates about whether or not the combination of gable and ridge vents substantially reduces the effect of the soffit vents by having the intake now at the gable vents and exhaust at the ridge. Would this type of ventilation affect the truss warranty?

Proper Storage And Shipping Of Trusses

Question: 

I would like to know the proper storage and shipping of wood trusses.

Lumber Fatigue And Decay

Question: 

What is fatigue in lumber and how does long-term fatigue affect lumber? Does long-term fatigue cause cracks in lumber? What is the difference between long-term fatigue and decay? How do you determine whether lumber has been subject to long-term fatigue or decay?

Lumber Concerns In High Temperature Low Humidity Climates

Question: 

I have been told that the high temperatures and low humidity present in attics can cause deterioration of wood, leading to truss failure. Is this true? If so, what length of time are we looking at and can we see the deterioration in the wood by visual inspection?