Materials

Uplift Values On Truss Design Drawings

Question: 

I am a building inspector and I have a question on information provided on truss design drawings. What does the uplift reaction number represent? Some manufacturers are very specific and state “to provide for mechanical connection of the truss to the top plate with a connector capable of withstanding a specific load.” Others simply list the uplift reaction with no further information. These are the ones that have caused a debate as to what the number actually represents.

Steel Vs Wood Truss Bracing

Question: 

As a forensic engineer who has investigated numerous collapses of wood truss systems, I find your web site an excellent resource on the proper erection of wood trusses. What are your opinions on steel trusses, particularly with regards to installation and bracing? Do you feel that the installation and bracing techniques utilized for wood trusses are applicable to steel trusses? Do you know if that is the general industry standard or are there specific requirements and guidelines for steel trusses? Is there a particular guideline/commentary available for metal trusses?

Sprinkler Loading

Question: 

Does the NFPA sprinkler standard address sprinkler loading? If so, how and where do I buy it? What other information do you have on sprinkler loading? How do other truss companies price jobs for sprinkler loading the plans do not include a sprinkler layout or even say what size/type of sprinkler system will be used?

Fire Damage Assessment

Question: 

How do you evaluate whether a metal plate connected truss is still usable after exposure to fire? Are there any recommended tests?

Location Of The Metal Connector Plates

Question: 

I was working on a job that had trusses that span more than 78 ft. with a 9/12 pitch. We had the #5 truss being installed when the #4 truss gave way. The trusses that were being installed are a two part system. The bottom set is what you would call hip trusses. The trusses contained 2x6 bottom chords, 2x8 top chords and rafters, and 2x4 webs. The roof sheathing was to be 3/4 in. plywood, 15 lb. felt paper and roof shingles. The ceiling was to be 5/8 in. drywall. The #4 truss sheared about 1 in. off the wall.

Trusses In Corrosive Environments

Question: 

I am a building designer on a salt storage building project. I would like to use metal plate connected wood trusses in the design. What should I specify for the metal connector plates?

Lumber Species

Question: 

What type of wood is usually used for wood trusses? I live in Louisiana and I would guess pine, but I want to make sure.

Fire Damaged Trusses

Question: 

I have been hired by an insurance company to determine the extent of damage to roof trusses exposed to fire. How much fire damage compromises the structural integrity of the truss?

Lumber Concerns In High Temperature Low Humidity Climates

Question: 

I have been told that the high temperatures and low humidity present in attics can cause deterioration of wood, leading to truss failure. Is this true? If so, what length of time are we looking at and can we see the deterioration in the wood by visual inspection?

Fire Rating For Sloped Roof Truss Assemblies

Question: 

A question has come up concerning sloped roof trusses and fire assembly ratings. Some are reluctant to rely on test results from flat (parallel chord) trusses applied to sloped roof trusses. Do you have any information regarding the suitability of the fire rated ceiling assemblies for sloped roof trusses? Does the “minimum depth” requirement of the parallel chord assembly apply to the minimum depth of a sloped roof truss (i.e., heel height?)